MAXX ECU plug and play wiring for Gen1 and Gen2 Hayabusa (ECU not included)

$600.00

I build a dash adapter that allows
the stock gauges to remain fully functional
now

Category:

Description

[Check out the videos tab on this page I have a playlist of a bunch of videos from MaxxECU stuff.]

You will need to purchase a premium race or sport MAXXECU kit, send me the flying lead harness and O2 sensor etc., and I can make the wiring a lot easier for you.  I can also supply wiring from scratch for an extra cost if you don’t have a flying lead harness to start with ($200 for a Race, $125 for Sport).  This ECU like most will require an ignitor of some type for the coils, the 4 channel ignitor like in the photos can be ordered with your Maxx when you purchase it, or a Holley dumb coil driver works as well.  There are options to mount the ignitor under the tank at the coils, but will cost extra to build this harness.

Completely plug and play wiring for MAXX Race ECUs, save the hassle of wiring on your own, just pull the stock ECU out, and put my wiring harness in and go 🙂

Stock gauges can be used on your Hayabusa, I now build a dash adapter that will take CAN data from Maxx and properly display coolant temp, FI light, and gear indicator (gen2 only) and ABC mode (gen2 only). You can also use a tablet or phone etc with bluetooth and mdash app for android to display anything, you can also use my digital dash with billet mount. There are also options to flip a switch and make your tach or speedometer read something different (like boost, air fuel, coolant temp etc).

I can repurpose many of the stock connectors on the bike to run things like shift light, air solenoid, shift cut input from horn, pressure sensors into secondary throttle senso/idle control, tipover sensor etc. In the photos was setup for a turbo bike with fuel pressure, oil pressure, 2 intake air temps for before/after intercooler, speed signal brought in for speed based functions, horn button brought in for shift kill, wastegate pressure brought in through stock map sensor connector, boost control add/remove solenoids plug into stock O2 sensor connector, flex fuel sensor plugs into SDS and tipover sensor connectors. Lots of options, really powerful standalone with tons of flexibility and what seems like daily updates!

Base setup comes ready to plug a MAXX Sport into your Gen1 or Gen2 Busa with O2 sensor wired (not sensor) and ignition coil driver wired (no driver). Maxx Race will have some extra harness charges.

Sorry, I don’t tune bikes, I am not a tuner, I like to wire and make plug and play products to make things easier for folks to access and have fun with.

Walkthrough / Install video I put together recently on a Gen2 Hayabusa.  https://youtu.be/tLe4F2cgjSw
Playlist of setup videos on mtune I put together here https://www.youtube.com/playlist?list=PLvetmkbHVrnSZKUSQj_RsDRWomSXQ_-5M

Reviews

There are no reviews yet.

Be the first to review “MAXX ECU plug and play wiring for Gen1 and Gen2 Hayabusa (ECU not included)”

Your email address will not be published. Required fields are marked *

Post comment