ECU Editor – Additional On-bike harnesses

$8.00$25.00

You must have the correct flasher to purchase these harnesses. The gen 1 and gen 2 flashing interface are NOT the same.

Clear
Category: SKU: N/A

Description

You must have the correct flasher to purchase these harnesses. The gen 1 and gen 2 flashing interface are NOT the same.

The flasher box’s that I sell for Gen 1 and Gen 2 Hayabusa / Bking do not stay on the bike, only a small harness stays on the bike, which you may purchase seperately if you are a shop and tune a lot of bikes, or if you have a buddy with the same year as your bike and you wish to share the flashing interface.

Gen 1 consists of the harness that goes from flasher box to 4 ecu pins, gauge data wire on a t-tap, and battery ground on a ringlet.

Gen 2 consists of just a 2 wire harness that goes from ecu connector to yosh connector. The main harness that goes from flasher box to yosh and sds connectors typically stays with the flasher box, just the 2 wire harness is the only thing that stays on the bike and would need additional items of to flash additional bikes.

Please note that while I do my best to ship items the business day after they are ordered, I am not always able to do this.

If you have an urgent need for anything, please email me directly greg@boostbysmith.com.

Domestic:  I ship most packages USPS priority mail, which is advertised as 2-3 business days.
Smaller items with shipping rates at just a few bucks are sent USPS first class mail.
I can ship UPS ground as well.

International:  Due to long delays with USPS during Covid 19, I am only shipping via UPS.
The customer is responsible for any brokerage/customs fees.  My site is setup to add $55
for international shipments as this is the worst case for UPS with rare exception of a remote service
zone fee which I will contact you if this is the case.

In the event that shipping is less than $55 I will send a refund.  Feel free to contact me in advance and I can check exact shipping for you.

Additional information

Weight 1 lbs
Dimensions 12 × 12 × 12 in
Harness Type

Gen 1 Hayabusa (02-07), Jumper Harness: gen 2 Hayabusa (08-12) / 07-11 GSXR-1000, Jumper Harness: 13+ Busa, Replacement Gen 2 Main Harness (Flash box to Yosh/SDS)

Reviews

There are no reviews yet.

Be the first to review “ECU Editor – Additional On-bike harnesses”

Your email address will not be published. Required fields are marked *

Post comment